The organic fertilizer production roughly includes two links: pre-fermentation and post-granulation. Organic fertilizer production equipment includes: fermentation turning machine, crusher, feeder, horizontal mixer, organic fertilizer granulator machine, dryer, cooler, sieve extension, weighing packaging machine.
The working part of the compost turner uses the motor reducer to drive the rotation of the rotary tillage harrow teeth, and the circular motion of the rotary tillage harrow teeth drives the material to turn up and down to achieve the effect of turning the pile to meet the needs of the moisture content of the material and good Oxygen fermentation needs, the power used is small, the production cost is reduced and the energy is saved, the whole machine has good rigidity, balanced force, concise, strong, high performance, easy to control, strong usability of the stacking site, and convenient use and maintenance.
1. After the dumper has been working for a season, replace the oil of the reducer, check the bearings of each part, disassemble and clean, and apply new butter. If the wear is serious, it should be replaced.
2. Take out the dust cover on the equipment, check and tighten the bolts on the transmission rod. Prevents parts from being damaged and scrapped due to loose bolts on the drive rod, causing underdrive of the various components.
3. Take out the cab seat and the cover under the seat, check and tighten the bolts on the rotating shaft. Prevent the bolts on the rotating shaft seat from loosening and causing the rotating shaft to loosen, resulting in axial tilt and torsion.
4. When using in winter, antifreeze should be added to the water tank. If no antifreeze is added, warm water should be added before operation. After the work is over, antifreeze should be added to the water tank. .The body. The water in the cooling tower is discharged to prevent freezing and cracking.
5. Check whether the electrical appliances work normally, whether the circuit insulation performance is good, and replace the connected wires if necessary.
7. When working for a long time, every exposed part should be oiled to prevent rust, and it should be covered when it is placed outdoors.
